ODH1-4RSICATG

4" GU10 35W Max. thermally protected air tight retrofit design housing


Description:
  • Commercial applications
  • Wire through junction box
  • Air tight & for the screw down clamps
  • Suitable for direct contact with insulation
Lamp Type GU10 PAR16 35W Max.
Diameter Ø 4-1/2" (cut hole size)
Lamp Size PAR16
Included Screw down clamps / Four hole quick connector

Install Trim Assemblies:

  1. Insert Trim into housing
  2. Push upward fully and pressure springs will hold trim in place.

 

Electrical Connection:

  1. Most dwellings built before 1985 have supply wire rated +60ºC.
    Consult a qualified electrician before installing
  2. Junction box contains three wires:
    a black (live+), white (neutral-) and bare ground.
    Make sure to connect white to white, and coloured or black to black
  3. After completing the wiring, snap wiring box cover closed

 

Air Tight Installation

  1.  Bar Hangers:
    Insert bar hangers into the slots on the plaster frame.
    Position bar hangers so that nail in tabs point away from housing or point down to ceiling
  2. Fastening Fixture to Ceiling:
    • Joist-type ceilings — Extend bar hangers to fit between joists.
    Position fixture temporarily by hammering "nail-in" tabs into joists.
    Then secure permanently with nails. Hangers should be level with bottom of joists.
    • Suspended (T-bar) ceilings — extend bar hangers 1" past T-bars then rest fixture on T-bars.
    Secure fixture to T-bars with wire
  3. Electrical Connection:
    Junction box contains two wires:
    a black (live+) and a white (neutral -), which must be spliced to the house current feed wires.
    Make sure to splice white to white and coloured or black to black.
    After splicing has been completed, tuck splices carefully into junction box and replace cover

Proud Partners