1. Home
  2. HVAC
  3. HEATERS
  4. HS-CH 2500W

HS-CH 2500W

2500W 240V AC Infrared Carbon Heater with remote control


Available Finishes:
  • Black

Description:
  • Comes with a remote control
  • For both ceiling and wall mounting
  • Produces instant and comfortable heat like the sun
  • High heat efficient energy saving comfort heat infrared carbon heater
  • Robust and weatherproof heater designed for commercial and residential heating applications for indoor and outdoor
Wattage 2500W
Voltage 240V AC
Amps 10.5A
Phase I
Material Aluminum, Plastic
Rating IC Rated / Indoor and Outdoor use
Grade of Protection IP 55
Application Restaurant / Garden / Stairways / Patios / Decks / Balcony areas / Walkways, etc.
Colour Black
Finish High temperature resistant powder spraying
Control ON/OFF switch
Coverage Area 183-279.9 ft²
Unit Dimensions 87.7 cm x 19.6 cm x 8.4 cm
Warranty 1 year

 

  1. This heater should be installed by a competant person (i.e. a qualified electrician)
  2. Always disconnect the heater from the electricity supply and allow it to cool before installation
  3. For ceiling mounting, the lowest part of the heater must be located or above a minimum height of 94-1/2" from ground level, so that the heater cannot be touched when in operation
  4. For ceiling mounting, there must be a 94-1/2" distance from your appliance to the ground
  5. When installed to the ceiling, there must be a distance of 19-11/16" between corners and the appliance
  6. The distance of your appliance from the living beings is to be one meter minimum
  7. The distance from the front side of the heater to materials such as wood, carton, cloth, etc. must be one meter minimum
  8. When mounting to a ceiling, DO NOT position the heater at an angle more than 90º and less than 45º
  9. The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically
  10. Keep the supply cord away from the body of the heater which will get hot during use
  11. DO NOT install the heater on an inflammable surface
  12. Observe the minimum safe distance between the heater body and the inflammable surfaces when mounted
  13. The heater should always have a minimum clearance of 19-11/16" from a ceiling and adjacent walls
  14. If the heater is to be used outside, a weatherproof outlet is recommended
  15. Before drilling, ensure that there are no wires or water pipes in the area where the heater is to be installed
  16. The heater must be installed on the mounting brackets provided
  17. Fasten the brackets securely to the mounting surface and the backside of the heater using the nuts and screws supplied
  18. Fasten the heater securely on the brakcets using the nuts and bolts supplied
  19. The brackets can be used to adjust the direction of the heater.
    Adjust the heater angle by loosening the two bolts on the wall mounting bracket.
    Tighten the bolts again when the desired angle is reached.

Proud Partners