1. Home
  2. HVAC
  3. Fireplaces
  4. OFP-50LED

OFP-50LED

50" wall mounted and built-in style fireplace with vent located at the bottom front


Available Finishes:
  • Black

Description:

  • Integrated remote control and touch control pad
  • Has 3 ember bed selections which plastic crystals, one piece log/stone consist
  • Automatic overheating protection with timer of 1 hour increments up to 9 hours
  • Two stage fan-forced air heater which you may use with the heater or without for ambiance
  • Includes LED 9 colour flame, one colour cycle and one off status and the same applies to the side lighting

Wattage High — 1300W / Low — 650W (2 levels of heating)
Voltage 120V 60Hz
Material One piece log/stone and plastic crystals
Installation Wall mounted and built-in
Timer 1-9 hours
Control Mode Touch Panel / Remote Control
Flame Colours 10 colours (9 colours + cycle)
Flame Brightness 1 level (Brightness cannot be adjusted)
Overheat Protection Yes
Heating Area 16-20m²

 

  • Please take out the foam that is inside the unit beforre using the heater
  • Remove the glass panel first, set the fire box into the wall.
    Secure the side trim pieces on the wall with screws.
    Reinstall the glass panel onto the firebox with screws.
  1. Remove the outer glass around the bracket, mounting screws
  2. Remove the outer glass
  3. Take out the foam
  4. Install the outer glass to the appliance:
    Lift glass panel and line up with the top bracket, fasten panel to the appliance.
    Screw the brackets to appliance with mounting screws
  5. Be cautious about the outer glass bracket screws


Glass Particles Installation

  1. To remove the outer glass around the bracket, undo the mounting screws
  2. Remove the outer glass
  3. Adjust the screws and carefully take out the log set
  4. Gently put the glass crystals into place
  5. Be cautious about the outer glass bracket screws
Proud Partners