25m length cuttable LED RGB strip of 30 LEDs per meter


  • Double sided 3M tape for easy installation
  • With multiple options for grade of protection
  • 5050 SMD light source synchronized colour change
  • Can be used with the channel listed on the accessory tab



Accesesories (sold separately):



Wattage 7.2W per meter
Voltage 12V DC
Lumens 175 lmn per meter
Beam Angle 120º
Lifetime 36000 hours
Dimmable Yes
Number of LEDs 30 LEDs per meter
Cut Distance 3 LEDs — 100 mm
Colours RGB / Multicolour
Rating Non-IC Rated / Indoor and Outdoor use / for *Dry, *Damp and/or *Wet locations
Grade of Protection IP 20 / IP 54 / IP 65 / IP 67 / IP 68
Application Cove lighting / Display lighting / Mood lighting / Under cabinet lighting
Operating Temperature -25ºC ~ +60ºC
Warranty 5 years

* Depending on your grade of protection choice, suitable location may differ

  1. Measure area needed for strip light installation.
    Cut the LED strip to the length at the closestt cut line.
    Peel 3M TAPE off back of the strip
  2. Press strip firmly in place with 3M tape backing.
    Double confirm the wattage and length of strip to choose power supply that is larger than the total
  3. Make sure to follow wire colours from the LED strip to the RGB controller.
    Ensure that the (+) and (-) wires are followed between the power supply and controller
  4. Cut as needed lengths of strip lighting off the roll.
    Use easy connectors as new power line by sliding strip under contacts on connectors.
    Make sure contacts match solder points as well as match colours

    * Use a 12V DC LED power supply ONLY
    * 12V AC will damage the controller and LEDs quickly

Proud Partners