2" 5 adjustable CCT LED slim regress downlight

Available Finishes:
  • White


  • Class 2 transformer in junction box is included
  • No housing required — Type IC, air tight & damp location rated
  • Easy & fast installation — install directly into ceiling with clips
  • Aluminum die-cast construction with beam spread option 38°


Interchangeable Reflectors (sold separately):

Alzek Chrome Alzek Haze Satin Nickel Baffle White Baffle Black Baffle




Interchangeable Rings (sold separately):

Shower Ring White Shower Ring Black Oval Ring White Oval Ring Black Small Round Ring White Small Round Ring Black


Regular Ring White Regular Ring Satin Nickel Regular Ring Black Scoop Ring White Scoop Ring Black




Accessories (sold separately):

PLATE2-HB PLATE26-2 CORD-12/24/60/120/240 DMD-ELV
Mounting plate for ORTECH 2" slim lights New construction plate for ORTECH 2" slim lights Flexible Connector 2FT/5FT/10FT/20FT Electronic low voltage dimmer switch with single pole 3 way wiring


Wattage 8W
Voltage 120V AC
Lumens 600 lmn
Beam Angle 38°
Lifetime 50000 hours
Cutout 2-7/8" (72mm)
CRI 80
Dimmable Yes
Rating IC Rated / Indoor use / for damp location
Grade of Protection IP 44
Air Tight Yes
Applications Recessed ceiling / Halls / Home / Office / Store / Cafe
Colour Temperature 2700K / 3000K / 3500K / 4000K / 5000K
Operating Temperature -20°C ~ +40°C
Warranty 5 years

Driver Wiring

  1. Open the hardwire box swing cover.
    Remove the appropriate knockout(s)
  2. Insert the electrical supply cable through the knockout.
    Secure with a cable connector (sold separately)
  3. Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box.
    Connect WHITE wire of cable to WHITE wire of box.
    Connect BLACK wire of cable to BLACK wire of box
  4. Place all wiring and connections back into the box and close the cover
  5. Insert hardwire box through the mounting hole


Fixture Installation

  1. Connect light engine. Be sure to properly align connectors.
    Fully screw down connector cover
  2. Connect the fixture to the hardwire box by inserting and twisting the male / female connectors
  3. Push spring loaded clips on the fixture upwards.
    Insert fixture base into the mounting hole.
    Release the clips and fixture will be pulled flush to the ceiling
  4. Once assembly is complete, turn ON power to confirm that fixture is working properly

Proud Partners