WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. 

PRE-INSTALLATION

1.    Turn power OFF from the electrical panel before starting installation.
2.    Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
3.    Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
4.    Align the inside edge of the Zero Clearnce plaster frame to the drywall hole and screw in place.
5.    Plaster over the plaster frame.be careful not to fill past raised rim.

DRIVER WIRING

1.    Open the hardwire box swing cover and remove the appropriate knockout (s).
2.    Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately).
3.    Using wire nuts, connect green ground wire of cable to green wire on box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box.
4.    Place all wiring and connections back in to the box and close the cover.
5.    Insert hardwire box through the mounting hole.

FIXTURE INSTALLATION

1.    Connect the fixture to the hardwire box by inserting and
twisting the male/female connectors.
2.    Select desires color temperature using the selector button
at the back of the fixture (preset to 3000 K).
3.    Insert the fixture to plaster frame , secure the lamp by twisting the fixture appropriately to the plaster frame.
4.    Once assembly is complete, turn on power to confirm fixture is working properly.