SLIM4-5CCT

4'' Ultra Slim LED Downlight With Adjustable CCT


Description:
  • Edge-lit technology, no glare or dark spots, instant-on
  • No existing recessed housing or junction box required
  • Dimming: TRIAC down to 10%
  • I.C. rated for direct contact with insulation (indoor only)
  • Suitable for Wet Location (indoor only)
  • Rated for a long life - over 50,000 hours
  • FT6 cable (plenum rated)
  • 5-color field selectable CCT - 27700K, 3000K, 350K, 4000K, 5000K

 

Decorative Trim Rings (sold separately):

SLIM4-RINGBK SLIM4-RINGSN SLIM4-RINGCH SLIM4-RINGVB SLIM4-RINGCBK SLIM4-RINGCP SLIM4-RINGBR

Accessories (sold separately):

PLATE4A-HB PLATE13-4A, PLATE13-4A-L, PLATE26-4A, PALTE26-4A-L CORD-B24/B120 DMD-ELV
Mounting plate for ORTECH 4" slim lights New construction plate for ORTECH 4" slim lights Flexible Connector 2FT/10FT Electronic low voltage dimmer switch with single pole 3 way wiring
Wattage 10W
CRI 90+
Color Temperature 2700K | 3000K | 3500K | 4000K | 5000K
Light Output(lmn) 934 lmn
Default Driver Input AC 120V, 60Hz
Dimming Triac Dimming
Rating IC Rated | Indoor Location
Grade of Protection Suitable for Wet Location (indoor only)
Air Tight Yes
Operating Temperature -20~+45°C
Beam Angle 120°
Warranty 5 years
Case Quantities 24

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. 

PRE-INSTALLATION

1. Turn power OFF from the electrical panel before starting installation. 
2. Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size). 
3. Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.  

DRIVER WIRING

1. Open the driver box swing cover and remove the appropriate knockout (s).
2. Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately). 
3. Using wire nuts, connect green ground wire of cable to green wire on box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box. 
4. Place all wiring and connections back in to the box and close the cover. 
5. Insert driver box through the mounting hole. New construction applications: driver box shall be
finmly secured to studs, joists, or similar fixed structural units. 
Remodel applications: Do not require the driver box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed. 

FIXTURE INSTALLATION

1.    Connect the fixture to the driver box by inserting and twisting the male/female connectors. 
2.    Push spring loaded clips on the fixture upwards and insert fixture base in to the mounting hole. Release the clips and fixture will be pulled flush to the ceiling.
3.    Once assembly is complete, turn on power to confirm fixture is working properly.

Proud Partners