SLIM6ID-WH

6" LED Slim Indirect Light in 12W for mounting under joists or duct work


Available Finishes:
  • White

Description:
  • Driver in connection box
  • Easy and Fast installation & no housing required​​​​​
  • Includes two spring loaded clips to attach to any ceiling material
  • Cut hole in ceiling and snap fixture in opening with attached spring clips
  • Can be installed directly into drywall and IC rated for direct contact with insulation

Accessories (sold separately):

PLATE6-HB PLATE26-6 DMD-ELV
Mounting plate for ORTECH 6" slim lights New construction plate for ORTECH 6" slim lights Single-pole 3 way dimmer

 

Wattage 12W
Voltage 120V AC
Lumens 700 lmn
Beam Angle 110°
Lifetime 50000 hours
Cutout ⌀ 6-19/64" (160 mm)
CRI 80
Dimmable Yes
Rating IC Rated / Indoor use / for Damp locations
Grade of Protection IP 44
Air Tight Yes
Application Drop ceilings / Office / Attics / Hallways / Bathrooms / Kitchens / Basements
Colour Temperature 3000K-2200K (Warm White) / 5000K-4000K (Cool to Natural White)
Operating Temperature -20ºC ~ +40ºC
Warranty 5 years

Connecting the Driver

  1. Open the cover of the junction box
  2. Push and remove one of the 1/2" knockouts on the side plate
  3. Install standard L16 cable connector
  4. Use double connector for daisy chaining multiple drivers
  5. Insert line voltage feed into the cable connector.
    Splice same colour wires using wire nuts
  6. Close the cover. Connect the driver to the light fixture — the arrows on the male and female parts of the connector — between the driver and the fixture should match
  7. Tighten the connector by hand. DO NOT attach the junction box to anything.
    This is so you can pull it through the ceiling opening in case you need to service the driver in the future

Proud Partners