1. Home
  2. LED
  3. Step Lights
  4. ST-PC1025


PIR and Photocell Step Light in 3W 120V AC with uniform light output and anti-glare function

Available Finishes:
  • White
  • Black


  • Turns light ON/OFF automatically with motion and light intensity
  • No screws on the pannel, and fits into 2" x 4" J-Box with minimum inside dimensions of 3" (Length) x 2" (Width) x 2" (Depth)
  • Energy savings dusk to dawn feature turns the LEDs ON when it is dark and OFF when there is light
  • Lights turn ON automatically when motion is detected and OFF after 1 minute when no motion is detected, automatically sensing the intensity of light, stays off even if there are people in the daytime light
  • Ideal for stairways, patios, decks, balcony areas, walkways, building perimeters, etc.
  • Easy installation — just install one screw above the lamp to save time
  • Photocell sensor comes pre-installed

Wattage 3W
Voltage 120V AC
Lumens 100 lmn
Beam Angle 120°
Lifetime 50000 hours
CRI 80
Dimmable No
Rating IC Rated / Outdoor use / for Wet location
Grade of Protection IP 54
Application Stairways / Patios / Decks / Balcony areas / Walkways / Building perimeters, etc.
Colour Temperature 3000K (Warm White) / 5000K (Cool White)
Operating Temperature -30°C ~ +40°C
Warranty 5 years


  1. Connect the wires of the fixture to wires on the outlet box with wire connectors, WHITE to WHITE, BLACK to BLACK.
    Loosen the GREEN screw in the mounting plate and then twine the GREEN line of the fixture to the GREEN screw, then secure it
  2. When wires are connected, tuck them carefully inside the outlet box and attach the mounting plate to the outlet box by using mounting screws
  3. Make sure that the mounting plate is at the same height as the wall.
    Assemble the face plate onto the mounting plate and tighten the hexagon socket nut with the Allen Key
  4. Restore power at fuse box / circuit breaker.
    Check the operation of the integrated LED fixture
  5. Installation is complete
Proud Partners