Fixture Installation

1. Cut a hole for the lamp. The plate is mounted on the board
2. Open the cover of the junction box.
   Push and remove one of half inch. Knockouts on the side plate.
   Tighten the connector by hand.
   DO NOT attach the junction box to anything so you can pull it through.
   The ceiling opening in case you need to service the driver in the future.
   Install standard 16 cable connector.
   Use double connector for daisy chaning multiple drivers.
   Insert line voltage feed into the cable connector.
   Splice same colour wires using quick connector. Close the cover
3. The spring loaded into the ceiling, and adjust smooth

Options for Locating Driver

1. Locate next to the fixture-run line voltage wiring to first junction box
   and daisy chain to the junction boxes of the fixtures
2. OR install all drivers in one location and use low voltage extension cables to the fixture.
   Use only extensions provided by the manufacturer