Pre-installation

1. Mount the appropriate trim on the module
2. Twist the trim to lock on the module securely
3. Turn power OFF from the electrical panel before starting installation
4. Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions
5. Run electrical wire from the switch (power supply) through the mounting hole — use NMD90 Romex or BX cable

Driver Wiring

1. Open the hardwire box swing cover and remove the appropriate knockout(s)
2. Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately)
3. Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box.
   Connect WHITE wire of cable to WHITE wire of box.
   Connect BLACK wire of cable to BLACK wire of box
4. Place all wiring and connections back into the box and close the cover
5. Insert hardwire box through the mounting hole

Fixture Installation

1. Connect the fixture to the hardwire box by inserting and twisting the male / female connectors
2. Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole.
   Release the clips and fixture will be pulled flush to the ceiling
3. Once assembly is complete, turn on power to confirm fixture is working properly