menu search close
  1. Home
  2. LED
  3. RESIDENTIAL LIGHTING
  4. Slim Lights
  5. 3 Inch Slim Lights
  6. SLIM3CONT-WH

SLIM3CONT-WH

6 pieces in one box 3″ LED Slim Contractor Pack available in 8W

Available Finishes:
  • White
Description:
  • Driver in connection box
  • recessed housing not required
  • IC rated for direct contact with insulation
  • Easy installation – Install directly into ceiling with clips


 

Trims (sold separately):

SLIM3-RING WH SLIM3-RING SN SLIM3-RING CH SLIM3-RING VB SLIM3-RING CBK SLIM3-RING BK
White Satin Nickel Chrome Vintage Brass Chrome Black Black

 

 

 

Accessories (sold separately):

PLATE3-HB PLATE26-3 CORD-24/60/120/240 DMD-ELV
Mounting plate for ORTECH 3" slim lights New construction plate for ORTECH 3" slim lights Flexible Connector 2FT/5FT/10FT/20FT Electronic low voltage dimmer switch with single pole 3 way wiring

 

Wattage 8W
Voltage 120V
Lumens 500 lmn
Beam Angle 120°
Lifetime 50000 hours
Cutout Ø 3-1/8" (78 mm)
CRI 80
Dimmable Yes
Rating IC Rated / Indoor use only / for Damp location
Grade of Protection IP 44
Air Tight Yes
Application Recessed ceiling / Balcony / Overhanging eaves, etc.
Colour Temperature 3000K (Warm White) / 5000K (Cool White)
Operating Temperature -20°C ~ +40°C
Warranty 5 years
  1. Turn power off from the electrical panel prior to installation
  2. Determine the location where you want to install the fixture
    and cut a 3-1/8" (80mm) hole in the ceiling according to the template on the box
  3. Open the junction box cover and remove the appropriate knockout(s) on the side panel
  4. Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately)
  5. Using quick-connect push-in terminals,
    connect the ground wire to the ground wire terminal;
    black wire to black wire terminal; white wire to white wire terminal
  6. Place all wiring and connections back into the junction box and close the cover.
    Connect the driver to the light panel
  7. Insert the junction box through the mounting hole
  8. Push clips on the fixture upwards and insert fixture base into the mounting hole.
    Release the clips and fixture will be pulled flush to the ceiling

Proud Partners